Marvel 41013943 Mode D'emploi page 4

4. Remove the power cord connector from the main
electronic board. Depress the latch on the inside of the
connector and pull down to disengage the connector.
See Figure 4. Place the end of the power cord with the
connector toward the back of the ice machine.
DRAIN PUMP INSTALLATION
Latch tab on
inside of
connector
Figure 4
5. Take the 18" wire harness from the drain pump kit and
connect it to the main board where the power cord con-
nector was removed. Remove the hex nut on the front
carriage bolt with a
and attach the ground wire under the hex nut. Tighten
the hex nut. Slide the plug end of the 18" harness
through the unit so it can be accessed from the back of
the ice machine.
Power cord
connector
Hex nut
Ground wire
4
⁄ " open end wrench (see Figure 5)
3
8
Figure 5