The Control Unit; Selecting The Location - Megasat Seaman 37 Mode D'emploi

2. Installation
2.2 The contron unit
Main power
USB connection for
Firmware Update
Connection
for antenna
Connection
for set-top box
Warning:
Connect the device only at a 7 amp protected line.
The line must be at least 2.5 mm² strong. (never directly to the car battery).
06
Satellite selection
Display (up / down)
LED displays Tracking function
(PWR = Power) (Disables automatic
(SEARCH = Searc)
tracking of the
(LOCK = Signal detected)
antenna)
(ERR = Error)
Port for Power supply
Service 12 V / 24 V
ENGLISH
2. Installation

2.3 Selecting the location

Direct Broadcast Service (DBS) satellites broadcast audio, video and data information
Reset
from satellites located 22.000 miles in space. A receiving station, such as the antenna,
should include a dish and satellite receiver to receive the signals and process them for
use by the consumer audio and video equipment. The system requires a clear view of
the satellite to maximize the signal reception.
Objects such as tall lighthouse, bridges and big ship that block this view will cause a loss
of signal. The signal will be quickly restored once the antenna has a clear line of sight
again. Heavy rain, cloud, snow or ice may also interfere with the signal reception quality.
If the satellite signal is lost due to blockage or severe weather condition, services from
the receiver will be lost (picture will freeze frame and may disappear). When the satellite
signal strength is again high enough, then the receiver will resume providing desired
programming services.
Good reception signal
ENGLISH
Bad reception signal
07