System Components; Installation; Connecting The Components - Megasat Seaman 37 Mode D'emploi

1. Introduction

1.4 System Components

Note:
The Seaman 45 and 60 additionally has a Auto skew function that automati-
cally adjusts the angle of polarization of the LNB and a GPS receiver for fast
and accurate positioning.
04
Antenna unit
The elegant plastic housing will protec-
ting the antenna against outside weather
conditions. Under the housing there is a
37 cm high-performance antenna (or a
45 cm or 60 cm). The new technology of
0-90° elevation enables optimal reception
across Europe.
Control unit (IDU)
The control unit is used for satellite selec-
tion and control. It is connected between
the antenna and the set-top box and sup-
plied the antenna with electricity.
ENGLISH

2. Installation

2.1 Connecting the components

Install the control unit and the set-top box inside the vehicle. Maintain a careful instal-
lation of the cable in order to avoid short circuits. Pay attention also to existing cables.
Connect the antenna as shown in the illustration below:
RED
(+)
( - )
BLACK
12~24 V DC 5 A
or with the optional
power supply
230 V AC / 12 V DC 5A
ENGLISH
05