Brinly P20-500BH Manuel Du Propriétaire page 8

Figure 5
5. Push the fl ow control handle downward to the
fully closed position, close the shut off plate under
the hopper, and hand tighten bottom nut on linkage
rod until snug. Hand tighten top nut on linkage rod
until snug.
Figure 6
6. NOTE: The edge of the wingnut is the marker, and not the center of
wingnut. When the fl ow control handle is opened fully, the edge of the
wingnut should be on the 30 mark.
Set edge of wingnut on 30 mark and tighten.
Move fl ow control handle upward and back downward, and verify the
shut off plate under hopper opens and closes properly. If necessary,
adjust linkage rod nuts and tighten hand tight.
1008066 Rev. D
ASSEMBLY
8