Ego Power+ BCA1200 Traduction De La Notice D'origine page 13

TROUBLESHOOTING
CAUSE
PROBLEM
◾
The battery pack is not attached to the
power head.
◾
No electrical contact between the power
head and the battery pack.
Brush cutter fails to
◾
start.
The battery pack is depleted.
◾
The lock-off lever and trigger are not
depressed simultaneously.
◾
The motor is overloaded.
◾
The battery pack or the power head is
too hot.
Brush cutter stops
while cutting.
◾
The battery pack is disconnected from
the tool.
◾
The battery pack is depleted.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
Attach the battery pack to the power
head.
◾
Remove battery, check contacts and
reinstall the battery pack until it snaps
into place.
◾
Charge the battery pack with EGO
chargers listed in this manual.
◾
Press down the lock-off lever and hold
it, then depress the trigger to turn on
the brush cutter.
◾
The motor will recover when the load
is removed. For continuous working,
decrease the load on the power head.
◾
Allow the battery pack or the power
head to cool until the temperature
drops below 67°C.
◾
Re-install the battery pack.
◾
Charge the battery pack with EGO
chargers listed in this manual.
BRUSH CUTTER ATTACHMENT — BCA1200
EN
13