Mr. Heater MH11BFLEX Instructions D'utilisation Et Manuel Du Propriétaire page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
3. Mr. Heater strongly recommends using
disposable fuel filter F273699 to trap
any oil substances when connected
to a remote cylinder that can make
heater inoperable.
4. Open valve at LP-gas supply cylinder.
5. Check all hose connections for leaks
with soapy water at the threaded
connection under the domed plastic
cover where the hose connector
screws into the regulator and at LP-gas
supply cylinder. DO NOT USE ANY
EXPOSED FLAME TO CHECK FOR
LEAKS. DO NOT OVERTIGHTEN. SEE
WARNING! ON DOMED PLASTIC
COVER.
6. Push control knob down slightly and
rotate counterclockwise to Heater
"Ignition/PILOT" position. See Figure 3
on previous page.
7. Push and hold control knob down
while holding down ignition button
until pilot is lit.
8. Release ignition button and continue
to hold down control knob down for
30-60 seconds and release. (If pilot
does not sustain flame, return to step
#4.
9. With pilot lit, push control knob down
and rotate to LO/HI setting position.
Shutdown Instructions
1. To shut off heater, shut off propane
at supply tank, allow heater to use-up
propane in supply line until heater
shuts off, then slightly push down and
turn control knob clockwise to "OFF"
position.
• When not in use, the gas must
be turned off at the LP-gas supply
cylinder. As stated before allow heater
to use up propane in supply line until
heater shuts off. When the LP-gas
supply cylinder is not disconnected
from the heater, the heater and the
cylinder must be stored outdoors, in a
well ventilated space, out of reach of
children, and must not be stored in a
building, garage or any other enclosed
area.
• Indoor storage of the heater is
permissible only if the cylinder is
disconnected and removed from
the heater. Cylinders must be stored
outdoors out of the reach of children
and must not be stored in a building,
garage or any other enclosed area.
Pulse Ignition
The Pulse Ignition Button is located to
the left of the control knob. Refer to
Figure 4 on page 5.
Open the battery cover located inside
the accessory compartment to install
the "AA" battery (included).
See Figure 5.
Accessory Mode Pre-Lighting
NOTE: Only approved Mr. Heater
accessories may be used with this heater.
Accessories are also available to use
with this heater. They may be attached
to the quick connect fitting in the side
compartment of the heater with the
hose included with the accessory.
IMPORTANT: Quick connect fitting is
designed for GAS OUTLET ONLY.
To pre-light accessory:
IMPORTANT: These steps explain how
to provide a gas supply to the accessory.
Refer to the Lighting Instructions in the
manual provided with your accessory to
ignite the accessory.
1. Make sure control knob is in "OFF"
position. See Figure 1 on previous
page.
2. Attach accessory hose onto the
quick connect fitting in the side
compartment of heater. See Figure 5.
3. Check hose connection for leaks
with soapy water at the threaded
connection where the hose connector
screws into the regulator. DO NOT USE
ANY EXPOSED FLAME TO CHECK FOR
LEAKS. DO NOT OVERTIGHTEN.
4. Push control knob down slightly
and rotate clockwise to Accessory
"Ignition/PILOT" position. See Figure 6.
5. Push and hold control knob down
while holding down ignition button
until pilot is lit.
6. Release ignition button and continue
to hold down control knob down for
30-60 seconds and release. (If pilot
does not sustain flame, return to step
#4.
7. With pilot lit, push control knob down
and rotate to ACC. "ON" setting
position.
8. Proceed to the lighting instructions
included with your accessory.
Mr. Heater | Portable Buddy Radiant Heater
Quick Connect Fitting
Ignition
Pilot
LO
HI
wire guard will remain hot. Allow to
thoroughly cool before storing.
propane cylinder indoors. A fire or
explosion can occur causing property
damage, serious injury or death!
To shut down the accessory:
1. To shut off accessory, shut off heater
gas supply first, then turn accessory
control knob to "OFF" position.
• Do not operate, store or remove
cylinder near flammable items or
ignition sources.
Refer to owner's manual included with
accessory for more detailed operation and
maintenance instructions.
6
Operating Instructions and Owner's Manual
Battery Cover
Figure 5
Acc
Ignition
Pilot
ACC
ON
Figure 6
CAUTION: After turning heater off,
DANGER: NEVER bring a refillable

Publicité

Chapitres

Table des Matières
loading

Table des Matières