Service - Endress+Hauser eco-graph Mise En Service

4. Setting up unit - SET UP

4.3.6 Service:

54
Information regarding the size and availability of the internal measured value
memory and the diskette drive. Displays the time for which the measured
values are available using the unit settings as they are.
Conditions:
- actual feed rate
- no alarm conditions/alarm feed rate
- digital inputs not used
Hints: The memory information takes the actually stored unit settings into
Memory information account as well as the conditions mentioned above. If changes have been
made but not yet stored then the respective memory info will only be updated
once the new parameters have been stored and the unit is returned to
"Normal operation" (operation of " " a number of times) and the changes
accepted and stored with "Yes". See "Setting up unit - Set up - Entry
principle"
The available memory time decreases when e.g.
- Alarms/events are to be stored or monitored
- Digital inputs are used.
• Display and settings for calibration, relay operating mode etc.
• Changes must only be made by qualified skilled personnel! The unit will not
operate properly if incorrectly set up! This will result in a loss of guarantee!
• General: Information for service technician, e.g. on questions to unit/unit faults
Unit software version. Please send these details with any questions about the
SW version
unit. Is also available in normal operation under the "Unit information".
Last power on Please send these details with any questions about the unit.
Last C-assertion Please send these details with any questions about the unit.
Attention: Resets all parameters to works default settings! All previous
PRESET
values, settings and memory contents are deleted !
Display addresses In addition to the help text also display the address number being set up.
CPU no. CPU number. Please send these details with any questions about the unit.
Display of the total unit operating time. Please send these details with any
Unit running time
questions about the unit.
Display of the total operating time of the rear illumination. Please send these
LCD running time
details with any questions about the unit.