Intended Use; Technical Data - Festool MX 1600/2 REQ DUO Instructions D'utilisation D'origine

English
2.3 Further safety instructions
– Check the plug and cable on a regular ba­
sis and, if they are damaged, have them re­
placed by an authorised customer service
workshop.
– The switch must be in the OFF position be­
fore you connect it to the mains.
– Always guide the power cable from the tool
to the rear. Never pull hard on the power
cable and never place it on or guide it over
any sharp edges.
– Only use a stirring rod with a diameter that
is specified in the technical data.
– Only work in a safe and stable position.
– Do not work in damp environments.
– If moisture has penetrated the power tool,
unplug the mains plug and have the power
tool checked by an authorised customer
service workshop.
– Do not stir hot materials.
– Take into account that there will be a reac­
tionary torsional momentum.
– Do not touch the connected power tool with
wet hands.
–
Wear suitable personal protective equip­
ment: Ear protection, protective goggles,
dust mask for work that generates dust
and protective gloves when changing tools,
sturdy shoes.
Only for AS/NZS: The tool shall always be
–
supplied via residual current device with a
rated residual current of 30 mA or less.
2.4 Other risks
Even in cases where the machine is used cor­
rectly and all relevant safety instructions have
been adhered to, the design engineering of the
machine and its operation mean that the fol­
lowing safety risks may also arise:
– Danger caused by the power cable.
– A concentration of dust which is harmful to
health when working in an area that is not
sufficiently ventilated.
– Injuries caused by touching electrified
parts when removing the machine or its
parts if the plugs on the power cable have
not been removed from the socket.
– You must only use original Festool spare
parts.
2.5 Emission levels
The levels determined in accordance
with EN 62841 are typically:
14
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
Vibration emission level a
three directions) and uncertainty K measured in
accordance with EN 62841:
The specified noise emission values
– have been measured in accordance with a
standardised test procedure, can be used
to compare one power tool with another,
– and can also be used for a provisional as­
sessment of the load.
CAUTION
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro­
tective measures must be defined in order
to protect the operator.
3

Intended use

The power tool is designed for mixing powdered
materials, such as mortar, plaster, adhesives
and non-solvent paints, varnishes and similar
substances.
The user is liable for improper or non-in­
tended use.
4

Technical data

Stirrer
Voltage
Frequency
Power consumption
Idling speed
1st gear
L = 85 dB(A)
PA
L = 96 dB(A)
WA
K = 1.5 dB
(vector sum for
h
a < 2.5 m/s
2
h
K = 1.5 m/s
2
MX 1600/2 REQ DUO
220–240 V
50–60 Hz
1500 W
100–250 rpm