Instructions; Prepare And Make A Measurement - Supertech Agroline Farmpoint Notice D'utilisation

Instructions

This section explains how to use the Farmpoint

Prepare and Make a Measurement

Inspect the two parts of the compression cell to make sure they are clean and empty.
If the temperature of the grain sample differs a great deal from that of the meter, e.g. when taking
measurements directly from the dryer, it is recommended to preheat the meter as follows:
a. Fill the test cell with the desired crop, grind it and wait approx. 1-2 minutes.
b. Proceed with the normal testing procedure as detailed below.
1 TURN ON DEVICE Press and hold the Power button "ON/TEST"
2 SELECT 'Measure' and press the ON-TEST button
Select the crop to be tested by using the arrow keys ⇑ or ⇓.
To select a different crop press the ESC/OFF button to return to MEASURE and use arrow keys ⇑ or ⇓ to
cycle through the options.
3 Fill the sample into the cup
Fill the test cell evenly with the desired crop until top is reached. Screw on the lid until the pressure indicator
is flush with the top of the lid.
4 Immediately press the ON/TEST button.
Press ON/TEST immediately. A series of asterisks will appear across the screen, followed by the moisture
reading.
The analyser will take ~10sec to measure the moisture content and calculate the temperature
compensation and hereafter display the result.
A new reading can be made by emptying and cleaning the test cell and filling it with a new sample. Do not
re-test the sample without first emptying and refilling.
Ver 1.1.0 GB
Page 6/13