Sonic Cleansing Brush Mode; Cleaning, Maintenance And Storage; Cleaning; Maintenance And Storage - QLARITE LEDSONIC+ Manuel D'utilisation

• We recommend to use the light therapy 3-4 times per week.
• If an area requires more rejuvenation, we suggested to extend the process
slightly over 3 minutes in that area.
C) Sonic cleansing brush mode
Avoid using clay-based, silicone-based or grainy cleansers, exfoliators or scrubs
as they may damage the soft silicone touch-points.

7. Cleaning, maintenance and storage

7.1

Cleaning

Caution: Before cleaning your LEDSONIC+, make sure that the power
switch is OFF and the power cord is disconnected from the charger base.
• Never clean LEDSONIC+ or any of its parts under the tap or in the
dishwasher.
• Never use abrasive cleaning agents or aggressive liquids such as petrol or
acetone to clean the appliance.
• Use the soft cloth included with your LEDSONIC+ appliance to clean the
following parts:
• The surface of the main body and charger base
• The surface of the attachments
• Always clean the sonic cleansing brush after use with water and soap, pat
dry with a lint-free cloth or towel.
• Avoid leaving your sonic cleansing brush in direct sunlight and never expose
it to extreme heat or boiling water. The life span will greatly increase with
proper maintenance and care.
7.2

Maintenance and storage

• Use the dry soft cloth, dip it in clear water to clean the surface of the ultrasonic
head and LED light head after each application.
• Store LEDSONIC+ in a dry place at a temperature between -10°C and 45°C.
• If you want to replace a part or want to purchase an additional part, please go
to your local provider or contact us at
7.3

Protecting the environment

• At the end of its life, DO NOT discard LEDSONIC+ with normal
household waste. Dispose of it at an official recycling collection
point.
www.qlarite.com.

8. Troubleshooting

Refer to this troubleshooting guide if you experience any problems with
LEDSONIC+, as this section addresses the most common problems you could
encounter with this appliance. If you still have problems, please contact your
local provider or contact us at www.qlarite.com.
device by yourself.
Problem Possible reason
The rechargeable batteries are
low in power
LEDSONIC+ does not work
The appliance is defective
LEDSONIC+ suddenly The rechargeable batteries are
switches off low in power
The appliance temperature
rises during operation and This is normal
recharge
Battery charging indicator
light ("SELECT" key orange
The POWER ADAPTOR is not
light) does not turn on when
plugged in the electrical outlet
connecting the PLUG into the
CHARGER BASE SOCKET
Don't open or repair the
Solution
Charge the appliance (see
section 5.1 "Charging"
Contact the nearest Qlarité
dealer
Charge the appliance
No action is required
Insert the PLUG into the
CHARGER BASE SOCKET.
Connect another wall socket
to check if the electrical outlet
is live
If it is still does not charge,
contact your nearest Qlarité
dealer