The Product At A Glance - Lux Tools 468273 Instructions D'utilisation D'origine

Table des Matières

Les langues disponibles

468273_Trimmer_Elektrisch.book Seite 35 Mittwoch, 11. November 2015 11:39 11

• Always keep a safe distance away from the cut-

ting tool.

• Make certain that the work area is free of obsta-

cles. Coming into contact with obstacles can

result in fatal rebounds.

• No other persons or animals may be present

within an area of 15 m around the cutting area,

as they may otherwise by hit by objects being

slung away.

• Only work when light and visibility are good.

• Do not work above hip height! Do not lean for-

ward or back!

• The operator must wear tight-fitting clothing.

Avoid wearing loose clothing. Wear sturdy shoes

and long trousers.

• Never reach into the work area (cutting tool/cut-

ting cord).

• Take care when walking backwards. Danger of

stumbling!

• Do not work on wet grass.

• Make sure you have a firm stand when working

on slopes.

• Never run when operating the device.

• Always work across slopes, never upwards or

downwards.

• Never work on steep slopes.

• The cutting tool still rotates for a while after the

product has been switched off. Only touch the

cutting tool when it has come to a complete

standstill.

• Protect the product against hard shocks! Do not

let it fall!

Information regarding cutting

• Only cut with the right-hand (here dark grey) part

of the cutting area by moving the product from

left to right in a semi-circle.

• Gentle and rebound-free cutting is possible only

in this area.

• Never set in the left-hand (here light grey) area

for cutting.

Here there is a high risk of rebound and objects

may be slung in your direction by the rotation of

the cutting tool. This may cause injury.

• When moving the product from right to left, you

must keep the cutting tool away from the

ground, so that nothing is flung away.

• Always cut long grass from top to bottom so that

it cannot wind itself around the cutting tool.

Cut with care:

• Only use the tip of the cutting tool. This saves

wear and tear on the cutting tool and avoids

grass being caught on the cutting tool.

• Only hold the cutting tool as closely as neces-

sary to posts, walls, fences and similar objects.

Hard objects wear the cutting tool down very

quickly and can damage it.

• Bark, young trees and bushes can be damaged

by the cutting tool.

Lengthening the cords (only with cord spool)

If the device no longer cuts cleanly, the cords have

become too short.

The best cutting results are achieved if you extend

the cords such that they are cut by the knife to the

right length.

WARNING! Risk of injury (cuts from

sharp edges)! Before any maintenance

and/or cleaning work:

– Switch off the product.

– Allow the product to cool down.

Extending the cords by hand

– Lay the product on the ground.

– Press your hand on the underside of the cord

spool and pull the two cords out until they are

slightly longer than the edge of the protective

shield.

The cords are cut to the right length by the cutting

knife when used again.