Magnat MA 800 Mode D'emploi/Certificat De Garantie page 9

OPERATIONAL ELEMENTS AND CONNECTIONS – REMOTE CONTROL
• Before using the remote control the supplied batteries must be inserted into the battery
compartment located at the rear of the remote control.
• If the batteries have run out after prolonged use, please replace them (type AAA).
• To prevent causing damage to the remote control please remove the batteries if the device is not
going to be used for a prolonged period.
• Battery disposal: Old batteries are hazardous waste and must be disposed of in accordance with
current regulations.
1 Power
Switches the device on when it is in the standby mode.
If the LED does not illuminate, actuate the power switch
located on the rear of the device. Conversely the device
can be switched from power operation to the standby
mode.
2 Display
This button can be used to adjust the brightness of the
display (3 levels) or switch if off completely.
3 Input Selecton
These buttons enable direct selection of the individual
audio inputs. The active input is indicated in the display.
4 Volume
Increases ( ) or decreases ( ) the volume.
5 Mute
Switches the sound on and off.
The non-numbered buttons are reserved for operating
the Magnat SACD player MCD 850 and have no
function for the MA 800.
GB
INITIAL OPERATION
• Place the MA 800 on an even surface. Observe the relevant clearance gaps as specified under
"Important safety instructions".
IMPORTANT: Do not place any objects on top of the device (magazines, CD/record cases, etc.).
The ventilation slots located on top of the device must be unobstructed at all times!
• Connect your speakers:
Single Wiring:
The stereo speakers (impedance of 4 to 8 ohms) are connected to the rear as follows:
Only use high-quality audio speaker cables with a conductor cross section of min. 1.5 - 2.5 mm².
Strip approx. 10 mm from the cables and twist the ends. Loosen the terminal screws one after the
other and insert the stripped ends into the holes. Re-tighten the terminal screws. Make sure you
pay attention to the correct polarity.
You can also use prefabricated cables with 4mm banana plugs or forked fittings.
Bi Wiring:
The MA 800 offers the opportunity to operate speakers in a bi-wiring mode by using a second
terminal pair. This means that the woofer and tweeter elements of the speaker are connected to
the amplifier with separate cables.
Also observe the operating instructions for the speakers you are using.
9