Defrosting; Replacing Of The Illuminant - Schneider SCB300V2 Mode D'emploi

3. Dry the cleaned surfaces with a cloth.
4. Check the water drain and clean it if needed.
 Clean with warm water and a mild, non- acidic detergent.

5.1 Defrosting

Cooling compartment
1. The cooling compartment is defrosted automatically. The water runs into a
container near the compressor.
2. If the automatic defrosting does not meet the requirements, e.g. on days with
high ambient temperatures and humidity, defrost the appliance manually as
described above.
Freezer compartment
1. Remove the contents from the freezing-compartment and put them into a
cooling box.
2. Place a container in front of the appliance to catch the water.
3. Switch off the appliance by turning the thermostat to position 0/AUS/OFF and
disconnect it from the mains.
4. When the encrusted ice melts put some dry cloths into the freezer-compartment
to hold the water back.
5. Remove the big pieces of ice first.
6. Afterwards remove the small pieces of ice.
7. Wipe and dry the appliance and door seals with dry and soft cloths.
8. After cleaning leave the door open for some time to ventilate the appliance.
WARNING! Do not use any steam cleaners to clean or defrost the
appliance. The steam can get into contact with the electrical parts and
cause an electrical short. Risk of electric shock!
NOTICE! Never use mechanic devices, knives or other sharp-edged
items to remove encrusted ice inside the appliance.

5.2 Replacing of the illuminant

WARNING The lamp on this device must only be changed by a qualified
technician!
1.
WARNING! Switch off the appliance and disconnect it from the
mains before you clean or maintain it.
2. Unscrew the illuminate-cover (1) and remove it (→).
Door seals
30