REICH C-Go 10A Instructions D'assemblage Et Mode D'emploi page 9

Index
1. Product description
2. Safety advices
3. Scope of delivery
4. Mounting and installation
5. Changing the charging characteristics
6. Display
7. Notes
8. Troubleshooting
9. Technical specifications
1. Productdescription
The c-Go 12V battery charger series was designed for the fully automatic charging of
12V lead-acid batteries. It may be used for the charging of gel and AGM batteries.
The charger is equipped with a highly efficient switching mode power supply. The
charging operation and control of the unit is effected via microcontroller. The use of
high-quality components ensures a high level of efficiency.
The loader was designed for continuous battery connection, while other consumers
are connected to the battery at the same time.
Make sure the energy consumption of the additional consumers will not exceed the
maximum loading current or the battery may not be charged.
When the safety regulations of this manual are observed and the charger is operated
in compliance with this manual, the batteries will be fully charged.
On top of that, the charger may be used for voltage supply purposes without a battery
connected. Depending on the version this mode will provide a voltage of 13.2V and a
maximum output current of 10A or 20A, respectively.
Caution: In the voltage supply mode the charger is not protected against reverse
polarity.
Read the safety advices carefully
Read the user manual before using the battery charger.
For indoor use only
Do not use the battery charger in a wet environment or in the rain.
The battery charger and batteries are not to be discarded with normal house-
hold waste. Dispose properly according to the local regulations.
The battery charger is a class II appliance (double insulated)
The battery charger complies with the European CE requirements.
GB1