Max PowerLite HN25C2 Manuel D'instructions D'utilisation page 9

Application Type
Securing a wooden Plastic
material to a thick Coil Nails
steel plate (For Steel
Plate)
When using, allow
for the nature of the
driving object and
the conditions at
the work site to
comply with the
Work Standards.
Wooden Material
Sinks 2 to 5 mm
(1/16" to 3/16")
Penetration Amount
Thick Steel Plate
Thick Steel Plate
Select the nails so that a
penetration amount into
the thick steel plate will
be 10 mm (3/8") or more.
Size (Leg Length)
• Drivable steel plate
thickness is 3.2 to 4.5 mm
(1/8" to 3/16"). Use the
Machine only within these
limits.
• Overdriving into the steel
plate reduces a holding
force extremely and
deteriorates durability of
the Machine. When
working, check the driving
condition fully to adjust the
pressure.
• Never drive the nails
directly into the thick steel
plate, because they may
recoil or bend, endangering
you.
• Be sure to apply the nose of
the ejection port to the
object at a right angle.
• Do not use the Machine for
the roof or ceiling.
6
Attachment Used
Attachment-B
Use of the attach-
ment-A causes a nail
sticking out to the
wooden material.