Maintenance - Schneider LD49-SCE68SK Manuel D'utilisation

Troubleshooting Guide
The wireless network
connection failed.
The software update over
the Internet has failed.
No picture when connecting
HDMI
Note: To properly watch CANAL+ using this product, carry out DVB -T
channel s earch w hen CA NAL+ i s uns crambled, fr om 12:30 p. m. to
1:30 p.m. and from 7:00 p.m. to 8:30 p.m.

Maintenance

Early malfunctions can be prevented. Careful and regular cleaning can extend the
amount of time you will have your new TV. Be sure to turn the power off and unplug the
power cord before you begin any cleaning.
Cleaning the screen
1. Here's a great way to keep the dust off your screen for a while. Wet a soft cloth in a
mixture of lukewarm water and a little fabric softener or dish washing detergent. Wring
the cloth until it's almost dry, and then used it to wipe the screen.
2. Make sure the excess water is off the screen, and then let it air-dry before you turn
on your TV.
Cleaning the cabinet
To remove dirt or dust, wipe the cabinet with a soft, dry, lint-free cloth. Please be sure
not to use a wet cloth.
Extended Absence
If you expect to leave your TV dormant for a long time (such as a vacation), it's a
good idea to unplug the power cord to protect against possible damage from
lightning or power surges.
Important Notice
The display of this television is made up of a large number of colour Although it has at
least 99.999% of effective pixels, some black dots or bright spots (red, green or blue)
may appear constantly on the screen. This is a characteristic of the screen (according
to industrial standards), and is not a defect. Sometimes, the screen may include an unlit
pixel, which will be seen as a blue, red, green or black dot. This does not affect the
functioning of the product and should be considered normal.
Technical data sheet
Sheet of household television according to EU directive 1062/2010
when the TV is connected to an audio receiver that
supports ARC.
- Make sure the Network Connection is set to
Wireless.
- Make sure the TV is connected to a wireless IP
router.
- Check the network connection status.
- If the TV is not connected to a network, connect to a
network.
- The upgrade stops if you already have the latest
software version.
- If an HDMI cable doesn't support High Speed HDMI,
it can cause flickers or no screen display. In this
case use the latest cables that support High Speed
HDMI.
36