Removing The Door - Necta Vending Solutions SpA Zeta 550-9 Installation, Mode D'emploi, Entretien

Fig. 25
1 - Extendable column guides
2 - Numbered slots
3 - Spacer adjustment holes
4 - Anti-friction element
IMPORTANT NOTICE!
All settings obtained with procedures described in the
previous chapters are only given as an indication, as
they depend on the geometrical characteristics and
mechanical resistance of the bottles.
Each single column must be tested to ensure its correct
operation.
Specific accessories must be used for irregularly shaped
or lightweight bottles.
© by NECTA VENDING SOLUTIONS SpA

REMOVING THE DOOR

Should the machine be installed in a room where access is
through an opening with a width less than the smallest
dimension of the machine, the door and the door frame can
be removed to temporarily reduce the depth to 750 mm.
The disassembly and reassembly operations must be
carried out by qualified personnel with specific knowl-
edge of the machine.
Because of the door and door frame bulk, such opera-
tions must be carried out by two persons.
To disassemble the door, do as follows:
- disconnect the electrical system connectors;
- disconnect the cable clamp;
- release one side of the door stop chain, undoing the
fixing screw;
- remove the plastic plugs and at the same time com-
pletely undo the mounting screws from the upper hinge,
taking care not to extract the pin from the door-door
frame assembly;
- lift the door-door frame assembly and remove it from
the lower hinge pin;
- remove the lower hinge.
After passing through the access opening, reassemble the
door proceeding in the inverse order.
Fig. 26
1 - Upper hinge mounting screws
2 - Upper hinge
3 - Electrical system connectors
4 - Door stop chain
5 - Door frame hinge
6 - Lower hinge
54
01 10 126-03