Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
12
US
CA
GAS CONNECTION FOR CDU-365
4 FOOT POWER CORD
ELECTRIC SUPPLY
POWER REQUIREMENTS:
120 VAC, 60 Hz., single phase.
CDU-304/CDU-365: 0.10 Amp. Max.
(Use 15 Amp. circuit minimum)
■
Always disconnect the electric supply cord from the wall outlet or turn off the electricity at the service disconnect
before servicing this appliance.
■
Observe all governing codes and ordinances when grounding, in the absence of which, observe National Electrical
Code ANSI/NFPA No. 70-1990.
■
Wiring diagrams are included in the service summary, attached to the bottom of the cooktop chassis.
■
The rating label is located on the bottom of the cooktop chassis, towards the front on the right-hand side.
COUNTER TOP
REGULATOR
Installer supplied
shut-off valve must
be easily accessible
inside cabinetry
GAS SUPPLY
Chassis
GAS CONNECTION FOR CDU-304
4 FOOT POWER CORD
• Required when unit is installed over Wall Oven
Top view
Rating label
FRONT
COUNTER TOP
REGULATOR
Installer supplied
90
0
Elbow
shut-off valve must
supplied*
be easily accessible
(CDU-304
inside cabinetry
only)
GAS SUPPLY
ELECTRIC SUPPLY
Publicité
Chapitres
Table des Matières
