Power Requirements - Fisher & Paykel CDV2 Guide D'installation

INSTALLATION INSTRUCTIONS
12
US
CA
GAS CONNECTION FOR CDV2-365 models
4 FOOT POWER CORD
ELECTRIC SUPPLY

POWER REQUIREMENTS:

120 VAC, 60 Hz., single phase.
CDV2-365 & CDV2-304 models: 0.10 Amp. Max.
(Use 15 Amp. circuit minimum)
■ Always disconnect the electric supply cord from the wall outlet or turn off the electricity at the service disconnect
before servicing this appliance.
■
Observe all governing codes and ordinances when grounding, in the absence of which, observe National Electrical
Code ANSI/NFPA No. 70-1990.
■
Wiring diagrams are included in the service summary, attached to the bottom of the cooktop chassis.
■ The rating label is located on the bottom of the cooktop chassis, towards the front on the right-hand side.
COUNTER TOP
REGULATOR
GAS SUPPLY
Chassis
GAS CONNECTION FOR CDV2-304 models
4 FOOT POWER CORD
• Required when unit is installed over Wall Oven
Top view
Rating label
FRONT
COUNTER TOP
REGULATOR
0
90 Elbow
supplied*
(CDU/CDV-304
only)
GAS SUPPLY
ELECTRIC SUPPLY