Using The Side Burner Lighting Instructions - Fisher & Paykel DCS BGC Serie Guide D'utilisation

USING THE SIDE BURNER
LIGHTING INSTRUCTIONS
First remove the burner cover and any cooking utensils from the burner grate. Push and turn the control knob
to the "HI" position until the burner is lit or 4 seconds pass. If the burner doesn't ignite, wait 5 minutes for any
accumulated gas to dissipate then try again. If the burner will not light after several attempts, check the trouble-
shooting instructions on page 18.
MATCH LIGHTING
Hold a lit fireplace match near the burner ports, turn the control knob counterclockwise to "HI". Rotate the knob
immediately once the burner is lit to the desired setting.
Note:
If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been
turned "off". This "extinction pop" is normal for propane gas.
16
Control
Knob
FIG. 11 BGC132 Shown