Noritz N-069M-DV-CA Guide De L'utilisateur Et Manuel D'installation page 133

Connecting Quick Connect Cord
Caution
1
The wire coloring on the Quick Connect Cord will
not be the same as the wire coloring from the
connection plug inside the unit.
* The remote controller can be connected to either
unit A or B.
Instruction for connecting the Quick Connect
Cord to each unit:
1. Turn off the power.
2. Remove the front cover of the heater (4 screws).
3. Pass the Quick Connect Cord through the wiring
throughway and into the unit.
4. Plug the connector on the Quick Connect Cord to
the receptacle inside the unit.
5. Attach the ground wire of the Quick Connect Cord
to the terminal block fixing plate.
(If the ground wire is not attached, electrical noise
may cause problems)
6. Secure the coupling cord with a clamp.
7. Replace the front cover.
For Quick Connect Multi System Installation
use a Quick Connect Cord (Sold Separately).
1.Red 1.Red
2.Black 2.Black
3.White 3.White
4.Green 4.Green
5.Blue 5.Blue
6.Blue 6.Blue
A
Quick Connect
Cord
Junction Box
1.White 1.Red
2.Green 2.Black
3.Red 3.White
4.Black 4.Green
5.Blue 5.Blue
6.Blue 6.Blue
B
"Quick Connect Cord" tag
Ground wire
Connector
Clamp
Wiring Throughway
Coupling Cord
57