Onkyo TX-NR474 Mode D'emploi page 67

> Before Start > Part Names
(P57) in the Setup menu. The same sound field setting is applied all ranges when set to
"Off".
Cinema Filter: Adjust the soundtrack that was processed to enhance its high pitch range, in
order to make it suitable for home theater. This function can be used in the following
listening modes: Dolby Digital, Dolby Digital Plus, Dolby PL II Movie, Dolby Surround, Dolby
TrueHD, Multichannel, DTS, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master
Audio, DTS Neural:X, DTS Express and DSD.
0 It cannot be set if the listening mode is Pure Audio or Direct.
∫ Other
A/V Sync: If the video is behind the audio, you can delay the audio to offset the gap.
Different settings can be set for each input selector.
0 It cannot be set if the listening mode is Pure Audio or Direct.
Music Optimizer: Improve the quality of the compressed audio. Playback sound of lossy
compressed files such as MP3 will be improved. The setting can be separately set to each
input selector. The setting is effective in the signals of 48 kHz or less. The setting is not
effective in the bitstream signals.
0 It cannot be set if the listening mode is Pure Audio or Direct.
Late Night: Make small sounds easily heard. It is useful when you need to reduce the
volume while watching a movie late night. You can enjoy the effect only when playing Dolby
series and DTS series input signals.
0 The setting cannot be used in the following cases.
– When "3. Audio Adjust" - "Dolby" - "Loudness Management" (P57) in the Setup menu
is set to "Off" and Dolby Digital Plus or Dolby TrueHD is being played
– When the input signal is DTS:X and "Dialog Control" is other than 0 dB
Panorama: Broaden the sound field laterally when playing in the Dolby Pro Logic II Music
listening mode.
Dimension: Adjust the depth of the sound field in the front to back direction when playing in
the Dolby Pro Logic II Music listening mode. Set a small number to move the sound towards
the front. Set a large number to move the sound back.
Center Width: Adjust the width of the sound field of the front channel when playing in the
Dolby Pro Logic II Music listening mode. Set a small number to concentrate sound in the
middle. Set a large number to distribute the central sound out to the left and right.
> Install > Initial Setup > Playback
Advanced Setup
Dialog Control: You can increase volume of the dialog portion of the audio in 1 dB steps up
to 6 dB so that you can make dialog easier to hear over background noise.
0 This cannot be set for content other than DTS:X.
0 The effect may not be selectable with some content.
We plan to provide support for the Dolby Atmos audio format through firmware updates for
this unit. This means that the settings available depend on the version of firmware.
On firmware version before Dolby Atmos support
0 Panorama, Dimension, and Center Width can be set.
On firmware versions supporting Dolby Atmos
0 Panorama, Dimension, and Center Width cannot be set after updating.
| Supplementary Information | Others
67
En