3M Accuspray ONE Guide D'utilisation page 14

ATTENTION
Note: Do Not Put In Gun Washer.
Solvent left in the spray gun air passages could result in a
poor quality paint fi nish. Do not use any cleaning method
which may allow solvent into the spray gun air passages.
Do not expose air fl ow control valve and gauges to solvent
as damage may occur.
Cleaning Process
1. Relieve the air and fl uid pressure from the spray gun and cup before servicing.
2. To retain unused paint or temporarily store mixed material, see your Local, State, Federal and OSHA guidelines, along
with paint manufacturer's recommendations for storage.
3. To fl ush spray gun, run water or compatible and compliant solvent into the spray gun fl uid passage while triggering the
spray gun until the cleaning fl uid appears clear.
Note: If feasible, clean atomizing head prior to disposal. Dispose of all used atomizing heads and spray gun bodies in
accordance with federal, state and local regulations. To change the atomizing head, refer to the section "Attaching the
Atomizing Head" on page 8.
12