Connecting With A Vcr/15K Rgb/ Component Equipment - Sony VPL-PX1 Mode D'emploi

Connecting
Connecting with a VCR/15k RGB/
Component Equipment
This section describes how to connect the projector
with a VCR, external active speakers, and 15k RGB/
component equipment.
For details on how to connect a computer, see page 14
(GB).
Also refer to the instruction manuals of the equipment
to be connected.
When making connections, be sure to:
• turn off all equipment before making any
connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
Right side
S VIDEO VIDEO L AUDIO R
INPUT A MOUSE
Audio/video
S-Video cable
cable
(not supplied) (supplied)
to S video to audio/video
1)
output outputs
VCR
1) When both the S VIDEO and VIDEO jacks are connected to
the external equipment, the input signal from the S VIDEO jack is
selected.
16
(GB)
AUDIO OUT
AUDIO IN
1)
Active speakers
Right side
S VIDEO VIDEO
INPUT A
SMF-402 Signal
Cable
to RGB/
(not supplied)
component
3X phono jack y
output
HD D-sub
15-pin (male)
15k RGB/Component equipment
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
• When you connect the unit to 15k RGB/component
video equipment, select RGB or component with the
INPUT-A setting in the SET SETTING menu.
• Use the composite sync signal when you input the
external sync signal from 15k RGB/component
equipment.
L AUDIO R
AUDIO OUT
AUDIO IN
MOUSE
Stereo audio
connecting
cable
(not
supplied)
to
audio
output