SilverCrest SAB 160 A1 Mode D'emploi page 96

GB
Installing the device into the ISO duct
92
■ To avoid function disturbances the installation angle should be less than 30°.
■ Do not install the device in a location where it will be subjected to high
temperatures (i. e. direct sunlight or heating vents), heavy contamination and
strong vibrations.
■ In the event that changes to the vehicle are necessary contact your vehicle
dealer/qualifi ed radio installation facility.
♦ Pull the installation bracket
housing.
♦ Place the installation bracket into the ISO mounting duct.
♦ Bend the tabs on the installation bracket with a screw driver so that the
bracket is fi xed fi rmly into the mounting duct (see diagram).
♦ Check to make sure that the bracket is securely fi xed.
♦ Connect the ISO socket block of the device with the two ISO plugs on your
vehicle.
♦ Connect the antenna cable from the vehicle antenna to the antenna socket
on the device. The vehicle-specifi c DIN ISO adapter, which under circum-
stances you may need, is available from specialist workshops, specialist
shops or in the specialist sections of department stores.
♦ Feed the microphone unit cable into the aperture and connect it to the
microphone unit socket. Run the cable in such a way that the microphone
unit can be secured in the vehicle interior later, see also the section "Using
the microphone".
♦ Contingently connect the audio cinch cable of an external amplifi er to the
LINE OUT socket
♦ Contingently connect the audio cinch cable of an external subwoofer to the
yellow cinch socket SUBWOOFER
and the bezel frame
48
on the device.
40
on the device.
38
Installation
from the device's
47
SAB 160 A1