SilverCrest SAB 160 A1 Mode D'emploi page 114

Call accept/end
GB
Rejecting a call
To call
Redial
110
NOTICE
► Do not mount the microphone in the vicinity of speakers otherwise the voice
quality may deteriorate.
With an incoming call you will hear the call signal via the speakers attached
to the device and via your mobile telephone. The call number is shown in the
device's display.
♦ You accept an incoming call by pressing the TALK button on the micro-
phone unit or the
♦ You end the call by pressing the TALK button on the microphone unit again
or by pressing the
♦ With an incoming call press the
♦ Press the button
♦ With the number buttons on the device enter the phone number that you
want to call.
♦ Press the button again. The number is dialled and CALLING appears
in the display.
NOTICE
► If you make a mistake when entering the phone number press the
button to delete the last number entered. Each additional press
of the button deletes the last number respectively.
♦ Hold down the TALK button on the microphone unit or the
the device for approx. 2 seconds.
– If previously no call number was selected via the number buttons on the
device the last selected mobile phone call number is dialled.
– If previously a call number was selected via the number buttons on the
device this call number is dialled.
Handling and operation
button on the device.
button on the device.
button to reject that call.
. DIAL appears in the display.
button on
SAB 160 A1