Publicité
WiPro „all in one" Installation manual
3.1 Technical specifications
Supply voltage:
Supply voltage siren:
Current consumption:
Assignable transmitters max:
Transmitter frequency:
Transmitting power:
Range max:
Average battery life:
B attery type (transmitter):
Number of codes:
T emperature range:
I nterfaces:
3.2 Approvals
e1
This alarm system for recreational vehicles is tested and
approved according to the 72/245/EEC directive,
last amended by the 2006/28/EC directive.
3.3 Troubleshooting
If the following section does not resolve or describe the problem,
please contact our Technical Support Department: +49(0)431-66 66 811
Problem
WiPro does not respond to the command from the remote key fob
but the central locking system is working.
Possible causes
The vehicle is not listed in Table 1 under 1.7.
The DIP switch is not coded as described in Table 1.
CAN high and CAN low have been swapped over.
The CAN connection is not correctly assigned.
Problem
When arming the system, an open wireless magnetic contact
is signalled although all the contacts are closed.
Possible causes
WiPro has been isolated from the operating voltage and
no longer "knows" the state of one or more contacts.
Solution: open and close all the contacts several times.
9-30 V
12 V
< 10 mA
30
433.9 MHz
<10 mW
50 m in the open
2 years
C R2032 (button cell/3V)
>4 billion. (>4,000,000,000)
- 10°C to +80°C
R J11 (output for GSM module for alarm forwarding)
CAN bus interface
Page 14
GB
Publicité
