Sony VPL-HS1 Mode D'emploi page 10

1
Plug the AC power cord into a
wall outlet.
The ON/STANDBY indicator lights in red and
the projector goes into standby mode.
2
Press the [/1 (on/standby)
switch to turn on the projector.
The ON/STANDBY indicator lights in green.
3
Turn on the equipment
connected to the projector.
Refer to the operating instructions of the
connected equipment.
4
Press INPUT to project the
picture on the screen.
Each time you press the button, the input
indication changes. (1 page 15)
INPUT
5
Adjust the focus roughly using
the focus lever.
10
Step 3: Adjusting the Picture Size and Position
GB
ON/
STANDBY
Lights in red.
ON/
STANDBY
Lights in green.
VIDEO 1
Focus lever
6
Adjust the size and position of
the picture to fit the screen
using the zoom lever and
adjuster.
Move the zoom lever to adjust the picture size.
Use the adjuster to adjust the picture position.
Hold down and slide the adjuster stopper to the
right, move the projector, then replace the
stopper.
You can move the projector vertically and
horizontally within the following ranges:
Up to 20° each for horizontal angle
Up to 10° each for
vertical angle
Zoom lever
Adjuster stopper
Up to 2° each for
tilting angle