Display And Controls - OHAUS STARTER 300D Manuel D'instructions

STARTER 300D Portable DO Meter
1.3

Display and controls

Displays
8
1 Electrode condition
Slope: 80-125%
Electrode condition is very good
2
displays when manual endpoint, need to press button-Read to lock the reading,
means auto endpoint mode, meter judges the endpoint(reading is stable) and locks
the reading automatically.
3
Measurement icon -
4 Calibration icon -
5
Setup icon -
6
Power always on icon -
operation (see 4.4)
7 Battery status icon - fully charged, half-charged or fully discharged
8
ppm, mg/L or % for DO reading or calibration; mbar, hPa or mmHg for pressure entry; ppt
for salinity entry
9 Calibration point
10 Auto Temperature Compensation (ATC); Manual Temperature Compensation (MTC)
11 Temperature during measurement or Offset in calibration process
1
9
measurement or calibration is running
calibration in progress
instrument is in the setup mode
Meter will not automatically turn off after 10 minutes no
; Memory number
3
2
10
Slope: 60-80%
Electrode condition is not so good,
needs attention or cleaning
; Error index
4 5 6 7
11
EN 3
-