Safety Precautions; Display And Controls - OHAUS STARTER 300C Mode D'emploi

EN-2
1.2

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this
equipment. Failure to comply with these warnings could result in personal injury and/or property
damage. Retain all instructions for future reference.
 Use the equipment only in dry locations.
 Dry off any liquid spills immediately. The instrument is not watertight.
 When using chemicals and solvents, comply with the instructions of the chemical producer
and the general lab safety rules.
 Use only approved accessories and peripherals.
 Operate the equipment only under ambient conditions specified in these instructions.
 Do not operate the equipment in hazardous or unstable environments.
 Service should only be performed by authorized personnel.
1.3

Display and controls

Displays
6
7
1
Endpoint stability icon
2
Measurement icon -
3
Calibration icon -
4
Setup icon -
5 Battery status icon shows the condition of the batteries - fully charged, half-charged or fully
discharged
6 TDS factor in the setup mode
7 Conductivity / TDS / Cell Constant
8 Standard
9 Temperature during measurement or reference temperature in setup mode
STARTER 300C Portable Conductivity Meter
1
8
; Auto endpoint icon
; measurement or calibration is running
; calibration in progress
; instrument is in the setup mode
/ Memory number
2 3
9
/ Error index
4 5