Horizon Hobby Spektrum AR400 Guide De L'utilisateur page 8

EN
3. Move the throttle stick to the desired failsafe position, normally low throttle.
4. Follow the procedures of your specific transmitter to enter Bind Mode.
The system will connect within a few seconds. Once connected, the
LED on the receiver will turn solid, indicating the system is connected.
5. Remove the bind plug to prevent the system from entering bind mode
the next time the power is turned on.
6. After you've set up your model, rebind the system to reset the failsafe.
AR400 Failsafe
• Prevents unintentional electric motor response on start-up.
• Establishes low-throttle failsafe if the RF signal is lost.
• R emoves servo output pulses to all channels except the throttle channel
during failsafe.
• F ailsafe position is stored via the throttle stick position on the transmitter
during binding.
HOW AR400 FAILSAFE WORKS
Receiver Power Only
• When the receiver only is turned on (no transmitter signal is present),
the throttle channel has no output. This prevents arming of the
electronic speed control.
8
Shown using a separate receiver pack.
The battery can be plugged into any open
port except the Bind port.
Shown using an ESC/BEC and flight pack.