Toshiba Carrier RAV-SP180KRT-UL Manuel D'installation page 31

+001111052201_00Ta.book Page 30 Friday, November 20, 2009 11:45 AM
High-Wall Type
How to set the SW01
1. Remove the front panel.
• Before removing the front panel, direct the
horizontal louver to the direction shown in the
figure below.
• Remove the screws securing the front panel, and
detach it from the indoor unit.
2. Remove the drain guide and disconnect the
ground wire, TCJ sensor, TC sensor, and
motor lead (louver motor, fan motor).
3. Remove the screws and detach the electric
parts box.
Drain guide
TCJ sensor
Screw
S
L L
1 2
U U A B Fan motor
3 4
lead
Louver
motor lead
Screw
(For fixing the
electric parts box)
– 30 –
TC sensor
Ground wire
4. Remove the electric parts box cover and
set bit1 of SW01 on the board to ON.
(Do not touch SW02 as it is used for other
setting.)
Installation Manual
EN
30-EN
Toshiba