Warnings In Maintenance Works; Installation And Assembly; Positioning And Location Of The Spa; Outdoor Installation - Aquavia Swimspa Fitness Spa Manuel D'installation

INSTALLATION AND ASSEMBLY

2.3. WARNINGS IN MAINTENANCE WORKS

• Before carrying out any electrical or mechanical maintenance work, make sure that the machine
is disconnected from the mains, and that the start-up devices are blocked.
• Do not handle the equipment with wet feet.
3. INSTALLATION AND ASSEMBLY
Before installing and assembling the Spa, ensure that the packaging of the Spa is in perfect
condition. Contact your distributor immediately if the packaging is damaged.

3.1. POSITIONING AND LOCATION OF THE SPA

Position the Spa horizontally, placing the whole base of the unit on a smooth, flat and level surface,
capable of supporting the weight when used (full of water, plus the weight of the bathers).
The Spa cannot be placed on a curved surface or on blocks.
The side where the motors are located should be fully accessible. In order to carry out maintenance
tasks, the location of the Spa should enable it to be moved so that all its sides can be easily accessed.

3.2. OUTDOOR INSTALLATION

If an outdoor location is chosen to place the Spa:
Do not expose the Spa to sunlight when it is empty and without a protection cover. Remember
that prolonged exposure to sunlight may damage the surface of the Spa and its accessories. Acrylic
rapidly absorbs heat from the sunrays reaching very high temperatures which will damage the
Spa. Maximum absorption temperature is 60ºC.
It is recommended to place the Spa away from trees, as falling leaves may block the filter.
If the Spa is placed inside glass structures, prevent sunrays shining directly on the Spa through
the glass, as the temperature could be excessively hot.
6 Spa for private use - Installation Manual