Aquavia Swimspa Fitness Spa Manuel D'installation page 15

ELECTRICAL CONNECTION ENG
WARNING
It is essential that the owner of the Spa tests the differential switch at least once a
month, to check its good working order.
Check that the differential is in the OFF position. Do not place the differential in the
ON position until the Spa is filled with water.
Connect the electrical control panel of the Spa to the differential switch
Before carrying out any work on the Spa, make sure it is disconnected from the mains (differential
switch in the OFF position, or disconnect the cable from the mains).
Use a suitable cable from the differential switch to the electric cabinet of the Spa, depending on
the location and applicable law. The cable section will vary depending on the Spa model and the
distance of the installation.
The required kW are indicated in the appendix Technical Specifications of the Spa. The maximum
power must be considered, depending on the "High Amp" or "Low Amp" configuration
High Amp / Low Amp setting
Power consumption can vary considerably depending on the spa setting selected. Therefore,
the type of installation chosen will determine the amount of electricity consumed.
LOW AMP:
This setting disconnects the electric heater when any of the massage pumps are working,
which reduces electricity consumption. This is the manufacturer's default configuration.
HIGH AMP:
This setting makes it possible for all spa components to work at the same time. This type
of installation consumes more power.
15