AEG SCB61816NS Notice D'utilisation page 13

Problem
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "FROSTMATIC func-
tion" is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "FROSTMATIC func-
tion" is switched on.
There is no cold air circula-
tion in the appliance.
ENGLISH
Solution
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait un-
til the function resets automat-
ically to set the temperature.
Refer to "FROSTMATIC func-
tion".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Add less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.
13