HeathCo HZconnect Guide De Démarrage Rapide page 16

8c
TRANS
Insert either of the bare wires from the power module
into the empty opening of the quick connector with
the wire you labeled "TRANS" (fig. 7a) and lower the
Insert the remaining bare wire from the power
module into the empty opening of the quick
connector with the wire you labeled "FRONT"
(fig. 7b) and lower the orange arm fully.
Connect the spade connector (fig. 7c) that is
connected to the wire you labeled "TRANS" to the
"TRANS" screw terminal on the chime and tighten
Connect the spade connector that is connected
to the wire you labeled "FRONT" (fig. 7d) to the
"FRONT" screw terminal on the chime and tighten
Wire The Power Module
fig.7a
orange arm fully.
FRONT
fig.7c
screw.
screw.
16
fig.7b
fig.7d