English - FIBARO FGT-001 Mode D'emploi

ENGLISH

FIBARO Heat Controller is a remotely controlled
thermostatic head to control temperature in your
room. It measures the temperature and automati-
cally adjusts the heat level.
It can be mounted without tools on three types of
thermostatic radiator valves.
You can create schedules via app to easily manage
temperature throughout the week.
First launch
1. Connect the charger to the micro-USB port to
charge the device.
If you have the temperature sensor:
a. Use a coin to open the battery cover by
turning it counter-clockwise.
b. Remove the sticker underneath the battery.
c. Use a coin to close the battery cover by
turning it clockwise.
2. Disconnect the charger when the LED ring
pulses green (device fully charged).
3. Dismount your current thermostatic head.
4. Depending on type of your valve:
M30 x 1.5 Danfoss RTD-N
Proceed
normally
Danfoss RA-N
Use
adapter: adapter:
Read
attempting to install the device!
For full instruction manual and
technical specification please visit
our website:
manuals.fibaro.com/en/heat-controller
5. Mount the device on the valve and tighten it by
turning the cap clockwise.
6. Press and hold the button for at least 1 second.
7. The LED ring will start blinking blue.
If you have the temperature sensor:
a. Click the button on the
temperature sensor.
b. The LED ring will blink
green 5 times if the connec-
tion was successful.
8. Set the main Z-Wave controller in add mode.
9. Triple click the button on the thermostatic head.
The LED ring will start blinking white.
Use
10. If you are adding in S2 authenticated mode,
type in the device pin code (underlined part of
the public key on the label).
11. Successful adding will be confirmed by the
controller.
3
the manual before