Hidden Cam; Black 1-9/16" Flat Head Screw - Sauder Parklane 419152 Instructions D'assemblage

Step 11
BLACK 9/16" LARGE HEAD SCREW
(16 used for the BRACKETS)
1
D3
D262
å Pull a set of DRAWER FRONT BRACKETS (9G) apart and slide
them into the grooves in the DRAWER SIDES (D257 and D262).
You may need to gently tap them in with a hammer.
å NOTE: The DRAWER FRONT BRACKETS are marked "RH" and
"LH" for easy identifi cation.
å Fasten the DRAWER FRONT (D3) to the DRAWER FRONT
BRACKETS (9G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
3
Surface with

HIDDEN CAM

Fasten the DRAWER BRACE (M64) to the DRAWER
å
FRONT (D3). Tighten one HIDDEN CAM.
www.sauder.com/service
Push down
1S
9G
D257
Maximum
210 degrees
Minimum
190 degrees
Hidden part using
recycled material.
Color may vary.
M64
D3
VIEW THE T-SLOT BOX VIDEO
2
(4 sets used)
D262
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide a DRAWER BOTTOM (D981) into the grooves
å
in the DRAWER SIDES (D257 and D262) and
DRAWER FRONT (D3).
4
Arrow
D262
Fasten the DRAWER BACK (D175) to the DRAWER
å
SIDES (D257 and D262) and DRAWER BRACE (M64).
Use fi ve BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the other DRAWERS.
419152
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D981
U n fi
n i s h
e d
s u r
f a c
e
D3
D257
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

(20 used in this step)
D175
M64
D257
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 15