To Fit The Foot Straps On The Board; To Fit On The Mast Foot Of The Rig - F-One PAPENOO Convertible Manuel

To fit the foot straps on the board

1
• Use the screws provided with a Philips screw driver.
Choose your preferred position amongst the selection
of positions. If you are not sure, use the central po-
sition.

To fit on the mast foot of the rig

1
• Set the nut of your mast foot as far out as pos-
sible and insert the mast foot into the main ope-
ning of the track
2
• Fasten the screw, through the foot strap, into the
plastic insert of the board. Do not forget the washers
(1x plastic + 1 stainless steel) and watch the angle of
the screw to avoid damaging the board.
2
• Slide the mast foot to your preferred position
and tighten until it's firmly fixed in position
22