Disassemble The Foil From The Board; When Using The Papenoo Convertible For Sup Foiling; When Using The Papenoo Convertible For Wind Foiling - F-One PAPENOO Convertible Manuel

Assemble a foil together with the board equiped with twin tracks
1
3
• Insert 2x M6x25 screws into the two front holes
of the top plate and assemble with the T-nuts (a
few turns only to keep them as loose as possible).
• Place 2x M6x25 screws, assembled with 2x
T-nuts (a few turns only to keep them as loose
as possible), into the twin tracks and slide them
to the back.

Disassemble the foil from the board

• Untighten the 4x screws of the top plate and
slide the 2x rear ones out of the top plate slot.
• Slide the top plate backward until you are able
to pull the 2x front T-nuts out through the main
opening of the track

When using the Papenoo Convertible for SUP foiling

• Place 2x M6x25 screws, assembled with 2x
T-nuts (a few turns only to keep them as loose
as possible), into the twin tracks and slide them
to the back.
• Place the 2x front holes of the top plate over
the 2x M6 inserts located forward of the twin
track and fasten with 2x M6x25 screws (no T-nut
needed)
• Bring the back screws into the rear slots of the
Top Plate
• Fasten the 4x screws with a Torx tool until they
are tight.

When using the Papenoo Convertible for Wind foiling

• Follow the standard process to assemble the
foil over the board using the twin tracks only.
• Windfoiling requires the foil to be set towards
the back of the tracks.
2
4
• Bring the mast and top plate over the twin track
area and slide the two front T-nuts into the ope-
ning of the track.
• Slide the plate forward until you are able to
slide the back screws into the rear slots of the
top plate.
• Place the top plate at the desired position along
the twin tracks and fasten the 4x screws with a
Torx tool until they are tight.
• Keep the back screws into the track and tighten
them to keep them safe.
21
5