Sony MDR-RF5000K Mode D'emploi page 25

Symptom Cause and remedy
The battery , Check if the CHG indicator turns on. If not, put the headphones on the
cannot be
charged
, Dry batteries are installed.
, Rechargeable batteries other than the supplied are installed.
, The transmitter's contact pin and headphones' contact point are dusty.
The CHG indicator
, 3 and # of the rechargeable battery do not match those in the battery
blinks.
, The rechargeable battery is damaged.
RF signal
, Signal noise is output from the connected analogue component.
transmission does
not stop. (when the
INPUT SELECT
switch on the
transmitter is set
to "ANALOG")
, No power supplied to the transmitter.
No signal from
optical digital
output
, No playback sound from the connected external digital unit at the optical
, Connect the analogue out to the LINE IN jacks, and select the sound on the
Bilingual sound
cannot be selected
when using digital
input. (Both MAIN
and SUB can be
heard at the same
time.)
transmitter correctly so that the CHG indicator turns on.
• Insert the supplied rechargeable nickel-metal hydride battery.
• Insert the supplied rechargeable nickel-metal hydride battery.
• Wipe them with a cotton bud, etc.
compartment correctly.
• Insert the rechargeable battery with correct polarity.
• Replace it with a new one. The rechargeable battery, type BP-HP2000, is not
commercially available. You can order the battery from the store where you
purchased this system, or at your nearest Sony dealer.
• Unplug the connected analogue component, or set the INPUT SELECT
switch on the transmitter to "DIGITAL," and make sure playback of the
component connected to the DIGITAL IN jack is stopped.
• Connect the transmitter to a power source.
input jack.
• Check that the external unit is playing back.
connected component.
Additional Information
(Continued)
GB
25