Publicité
Battery Replacement
When the battery is low (yellow LED blinking), replace the battery as soon as possible.
The Datalogger retains its stored readings even when the battery is discharged or when the battery is replaced; the data logging process will
however be stopped and cannot be re‐started until the battery has been replaced and the logged data has been downloaded to PC.
Use only one (1) 3.6V lithium battery (1/2 'AA'). Before replacing the battery, disconnect the datalogger from the PC.
NOTE: Leaving the datalogger plugged into the USB port for longer than necessary will shorten the battery life.
Replace battery as shown in diagrams. Observe battery polarity when installing.
Copyright © 2013 FLIR Systems, Inc.
Reservados todos los derechos, incluyendo el derecho de reproducción total o parcial en cualquier medio
www.extech.com
3
407760 V2.1 6/13
Publicité
