Flamingo 521374 Manuel page 6

EN
Manual
1. Start-up mode: Install battery and start automatically or by pressing the start
button
2. 2 available buttons, UNIT & ON/OFF
3. ON/OFF: With a short push on the button you turn on the scoop. The display
shows 0 g. If there has been food or water in the scoop, briefly press the on/off
button to set the display back to 0 g. With a long push on the button (longer than
3 seconds) you turn the scoop off again.
4. By pressing the UNIT button, you can easily switch between 5 different
measuring units: g-oz-ml-fl oz-cup
5. Maximum weight: 1 g-500 g. When less than 3 g the display will automatically
show 0 g
6. If the battery voltage is low, "Lo" will appear on the LCD screen. After four
seconds, the scoop will automatically enter standby mode.
7. Overweight warning: if the weighing value is greater than 500 g, 'o-d' will
appear on the LCD display.
8. Switch-off time in case of overweight: 5 seconds
9. Automatic standby mode: after starting up and the display shows 0 g: +/- 60s;
after weighing and stabilizing: +/- 60s; in case of instability during weighing, the
scoop will not enter standby mode
10. If the weight is less than 1g, the display will show "---" and go into standby
mode after +/-60s. At a weight of more than 500 g, "o-d" will appear on the
display.
11. If the scoop is not used at all and the change in weight does not exceed 10 g,
it will automatically go into sleep mode.