Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting:
No sound:
- Ensure that the mains adapter is pushed fully into the power outlet and that its cable is
properly connected to the DC IN connector on the transmitter.
- Ensure that the headset receiver power ON/OFF switch is switched to ON.
- The charge level of the headset receiver battery may be too low. Recharge the battery
or replace it with a fully charged battery.
- Ensure that the TV set, Hi-Fi system or audio component is switched ON and set to a
channel that broadcasts an audio signal.
- Use the volume control on the Headset Receiver to increase the sound level.
- The connected audio/video equipment may not be in playback mode. Start playback on
by the equipment.
- The Headset Receiver output level is set too low. Adjust the volume to a suitable level.
Distortion:
- The charge level of the headset receiver battery may be too low. Recharge the battery
or replace it with a fully charged battery.
- The headset receiver may be too far away from the transmitter. Move closer to it.
- The audio signal input level is too low. Increase the volume from the audio source.
In case the headset receiver cannot be linked with the transmitter, please follow the
following procedure for pairing :
1. Turn OFF the power of the transmitter.
2. Turn ON the headset receiver.
3. Press and Hold the MIC Button for about 5 seconds, the green LED flashes quickly in
the headset receiver, then turn ON the power of the transmitter.
4. The headset receiver and the transmitter is then paired automatically, and the green
LED on the headset receiver lights steadily.
English 19
Publicité
