Publicité
Les langues disponibles
Les langues disponibles
The green power indicator LED will blink as soon as you have connected the power adapter
to the electrical outlet, when the audio signal is detected from the audio source, and the
green LED indicator will glow constantly.
Headset receiver
Insert a battery into the headset receiver with correct polarity.
Operation
1. Switch on the audio source (TV set or audio component) that the transmitter is connected
to. The green LED indicator will glow constantly.
2. Select the On/Off switch in the headset receiver to ON position, then the green signal
LED indicator glows.
3. Adjust the volume for desired sound level, then place it on the head.
4. The signal green LED indicator on the headphone will blink slowly with "Beep" in every
minute when the battery level is low. Recharge the battery.
Note:
Make sure the batteries provided in the packing, is fully charged before first use. Charge
the battery for about 3 hours before first use.
RF transmission of the transmitter will automatically switch OFF in approximately 5 minutes
if there is no audio signal, or the signal that it receives from the audio source is too weak for
proper reception. However, if the signal returns to an acceptable level, the transmitter will
automatically switch ON again.
16 English
Publicité
