Workplace - Hilti BX 3-SCT Notice D'utilisation Originale

▶ Do not attempt to drive fasteners into unsuitable materials.
▶ Unsuitable materials are glass, marble, plastic, bronze, brass, copper, insulating material, hollow
brick, ceramic brick, thin sheet metal (< 4 mm) and cellular concrete. Driving a fastener into these
materials may cause the fastener to break, splinter the material or to be driven right through.
▶ Pull the trigger only when the tool is fully pressed against the working surface at right angles.
▶ When driving fasteners, always hold the fastening tool at right angles to the working surface in order to
prevent the fastener being deflected by the surface.
▶ Keep the grips dry, clean and free from oil and grease.
▶ Never drop the tool.
▶ Do not use the tool in places where there is a risk of fire or explosion unless the tool is specially approved
for this type of use.

Workplace

▶ Keep the workplace tidy. Clear the work zone of objects that could cause injury.
▶ Untidiness in the working area can lead to accidents.
▶ Make sure that the working area is well lit and well ventilated.
Mechanical safety rules
▶ Do not tamper with or modify the tool or parts of it, especially the piston.
▶ Use only fasteners of a type approved for use with the tool.
Thermal safety rules
▶ Do not exceed the recommended maximum fastener driving rate (see the section headed "Technical
data").
▶ If the tool has overheated, allow it to cool down.
▶ Do not dismantle the tool while it is hot. Allow the tool to cool down.
2.4 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3 Description
3.1 Product overview
*2338837*
1
2338837
Fastener guide
@
Fastener guide locking catch
;
Air vents
=
Belt hook
%
Trigger
&
Grip
(
Release buttons (also used to activate the
)
charge status indicator)
Li­ion battery
+
Status indicator
§
On/off button
/
English 5