Gardeo GMTBT38HP35BS Mode D'emploi page 31

Wheels bracket
Insert the wheels support rod into the holes in
tailpiece bracket. Insert a O3 cotter pin through
the hole in the support rod to secure it.
Upper handle
1. Disassemble the handle adjustment knobs.
2. Mount the upper handle on the lower
handles with the handle adjustment knobs.
D
3 1
Upper
Handle
Retainer
Cone
Bolt
Inside
Adjuster
Throttle & clutch controls
1. Unwind the throttle control and clutch control
from around the engine. Straighten the cables.
Make sure that you do not bend or kink the
cables.
2. Remove the M6X60 carriage bolt and nut
from the throttle control assembly. Mount the
throttle control on the left side of the upper
handle with the hardware removed. Make sure
the throttle control is mounted outside the
handle.
3. Remove the M6X40 socket screw and nut
from the clutch control lever assembly. Mount
the clutch control lever on the right side of the
upper handle with the hardware removed.
Make sure the clutch control lever is mounted
on the top of the handle.
4. Use two cable clips to secure the clutch
control cable and throttle control cable in place
on the lower handles. Attach the clutch control
cable to the upper handle with another cable
clip.
Make sure the control cables are routed
properly.
Lower
Handle
Konb
Outside
Adjuster
E
3