Loading / Unloading The Nailer; Adjusting The Nail Penetration; Adjusting The Direction; Installing And Removing - Campbell Hausfeld CHN70600 Mode D'emploi

Operating Instructions and Parts Manual
Set-Up (Continued)

loAdINg / uNloAdINg tHe NAIler

Always disconnect the tool from the air supply before loading / unloading fasteners.
Choose which length of fastener you want to use for you project. Additional fasteners
can be found at major home centers.
loading the tool
1. Pull pusher back until it latches.
2. Insert nail clips into rear loading slot.
3. Press pusher latch button to release the pusher and allow it to engage the nail clip.
unloading the tool
1. Pull pusher back until it latches.
2. Dump the nails out the loading slot.

AdjustINg tHe NAIl PeNetrAtIoN

The CHN70600 is equipped with an adjustable depth of drive feature, ADC
thumbwheel (See Figure 11). This allows the user to determine how deep a fastener will
be driven into the work surface.
1. Adjust the operating pressure to a pressure which will consistently drive the
fasteners. Do not exceed the maximum operating pressure of the nailer of 120 psi.
2. To increase depth of drive, first pull up on the upper WCE, then rotate thumbwheel
to the left (counter-clockwise). To decrease depth of drive, rotate thumbwheel to the
right (clockwise). Then release upper WCE into detents which hold the thumbwheel
in place after each adjustment.
3. Make sure that the trigger and work contact element (WCE) move freely up and
down without binding or sticking after each adjustment.
AdjustINg tHe dIreCtIoN oF tHe exHAust
The CHN70600 is equipped with an adjustable direction exhaust deflector. This is
intended to allow the user to change the direction of the exhaust. Simply twist the
deflector to any direction desired.
INstAllINg ANd reMovINg No-MAr / stud FINder tIP
1. Disconnect air supply from nailer.
2. Remove tip from retainer storage location.
3. Carefully place no-mar tip over the end of work contact element.
4. Check that the WCE and trigger move up and down freely without sticking or
binding.
NOTE: To remove the tip, reverse the proceedure listed above.
Figure 9 - loading the Nailer
Figure 10 - Nail Bypass Button
Figure 11 - Nail depth Adjust
Figure 12 - exhaust Adjustment

No-mar tip

Stud finder
Figure 13 - No-mar / stud finder tip
installed
www.chpower.com
CHN70600
Press
Button
11