Start Up; Dry Vacuum Cleaning; Wet Vacuum Cleaning - Baier BSS 508-M Mode D'emploi

– This appliance contains harmful dust.
Evacuation and maintenance work, in-
cluding the disposal of the dust collec-
tion containers, may only be performed
by specialists who wear the appropriate
protective equipment.
– Do not use the appliance without the
complete filtering system.
– Please follow the safety regulations ap-
plicable to the materials that are to be
treated.
The appliance allows 2 operating modes:
1 Industry vacuum cleaner mode (socket
not used)
2 Dedusting mode (socket used)
 Connect the suction hose and insert the
suction nozzle or connect to the dust-
generating device depending on the op-
erating mode.
WARNING
The flat pleated filter must always be in
place while vacuuming.
WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pres-
sure.
 Set the rotary switch to the correct suc-
tion hose cross-section.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks with attachments with electrical
conductivity (included in the delivery).
16

Start up

Horn

Dry vacuum cleaning

– The device is equipped with a dust bag
with closing tape, order no. 73726
(10 units).
Note: You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with AGW values great-
er than or equal to 0.1 mg/m
– When vacuuming up suck fine dust, an
additional dust bag or a fleece filter bag
(special accessories) must be used.
Install fleece filter bag
Illustration
 Release and remove the suction head.
 Attach the fleece filter bag (special ac-
cessories).
 Insert and lock the suction head.
Installing the dust disposal bag
Illustration
Note: The opening of the disposal bag
must be pulled all the way over the ledge of
the suction support.
 Release and remove the suction head.
 Attach disposal bag.
 Pull disposal bag over the container.
 Insert and lock the suction head.

Wet vacuum cleaning

DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– 3
EN
.
3