Jled1: Rgb Led Connector; Jbat1: Clear Cmos (Reset Bios) Jumper - MSI H270M PRO-VDH Mode D'emploi

JLED1: RGB LED connector

These connectors allow you to connect the 5050 RGB LED strips.
1
1 +12V
3 R
Important
This connector supports 5050 RGB multi-color LED strips (12V/G/R/B) with the
y
maximum power rating of 3A (12V). Please keeping the LED strip shorter than 2
meters to prevent dimming.
Always turn off the power supply and unplug the power cord from the power outlet
y
before installing or removing the RGB LED strip.
Please use the LED Effect of GAMING APP to adjust, calibrate and control the LED
y
light, refer to the Software section for details.

JBAT1: Clear CMOS (Reset BIOS) Jumper

There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Resetting BIOS to default values
1. Power off the computer and unplug the power cord
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and power on the computer.
16
Rear I/O Panel
2 G
4 B
1
JLED1
Keep Data
(default)
Extension cable
Clear CMOS/ Reset
BIOS
5050 LED strip